Category: Meetings

Our next club meeting is on Thursday 16th September 2021, start time of 6.45pm. The meeting is to be a demonstration by John Ruickbie and John will be making a clock using some whisky barrel staves. John will be doing a solo demonstration with all the members seated, face masks will be optional whilst seated.

This was our first meeting after the pandemic restrictions were lifted that turning was involved, and it was good to be back in operation again. We have made some changes within the club to make it much safer for everyone to return, this included installing some ventilation fans and a CO2 monitor, and to combat any dust issues, we are currently installing a full dust extraction system to all the lathes and the bandsaw.

Our meeting on Thursday 2nd September 2021 will be in Munlochy, start time of 6.45pm.

Yes this is our first actual meeting where turning will be demonstrated after a very long shut down. I will be doing the demonstration, I’m going to make a thin walled end grain goblet made from a branch of fairly wet wood and leaving the top as natural edged as possible. To do this you will need to make up some sort of light assistance as you will see, and the procedure for turning this type of goblet is not what you might expect, all will be revealed on the night.

Our meeting this week on Thursday5th August 2021 was all about making wooden toys, the meeting was organised by Mike Day and Mike chose the subject matter, wooden toys. Mike also suggested that the toys could be made using some mobile parts to them, other than that he left the decision on what to make very much up to yourself.

Our next club meeting should be on Thursday 5th August 2021, however this meeting has been made into a virtual meeting due to the ongoing Covid-19 restrictions. The meeting is being organised by Mike Day and Mike’s theme for this meeting is to make wooden toys, any kind of wooden toys, turned or otherwise but what Mike would really like to see are toys with moving parts. He would also like to see a large entry for this meeting, so you are all being invited to make at least one toy, more if you can manage that, the past few weeks have seen a very small involvement from our members, lets not continue with this poor approach Mike and I want to see lots and lots of entries.

Our meeting this week on Thursday 22nd July 2021 was to make something that had a captive ring or rings. The meeting was organised by Errol Levings and it was Errol’s idea to put the project matter forward. The meeting had to done virtually due to the ongoing Covid 19 restrictions. You were all invited to take part, any item could be made, it could have been a goblet with a ring or rings or a mushroom, a vase, a candlestick anything at all the only important part was it had to incorporate a ring or rings.

Our meeting this week should have been our annual all day event, usually held on the Saturday following our usual meeting day, this can’t happen due to the ongoing Covid-19 restrictions, this meeting should have been organised and managed by Errol Levings, Earl has put forward a request that you all have a go at making something that has within it’s design a captive ring, and if you are really adventurous try putting more than one ring on. This lends its self well to be included on a goblet or a mushroom but for the ideas, Errol will leave that up to you.

Our virtual meeting on the 8th July 2021 was organised by Errol Levings, Errol’s theme for the meeting was Candlesticks and off centre Candlesticks. Errol had produced a plan along with his instructions on the making of one type of off centre Candlesticks, however it was stated that any sort of Candlestick or Candle holder would be accepted.

Our virtual meeting this week on the 8th July 2021 is being organised by Errol Levings, it’s going to be all about making candlesticks, all types of candlestick, whatever your imagination comes up with, you can go traditional or use nightlight candles or even some of the really fat candles, no matter what as long as you finish up with a candle or candles in your project.